Dt466 No Power - It will make noise if the engine is running. Do you mean it will not turn over when you turn the key? If so, do you hear a click when you turn the key to start? If you hear a. Turbo no end play and spins free from both sides no bad vanes. Cam position sensor changed. It does have a new turbo, back pressure sensor, map sensor, egr valve. All sensors have good 5v ref, and grounds. Turbo actuator has good 12v and ground even under. Check and see if it has a catalyst muffler. They didn't have a dpf, but they were equipped with sort of a catalytic converter inside a normal ish looking muffler. On flat ground, it can get up to it's normal cruising speed of about 62 mph, but it has no power pulling hills. Accelerating, it's fine until it hits third gear and about 2000 rpm, and. โข if low power complaint is intermittent, and voltage is 10 v or more, inspect turbocharger power and ground wires for corroded or loose connections. โ if power and. You probably have failed turbocharger actuator, turn ignition on, watch turbo linkage, linkage should move all the way out towards frame rail, move all the way back in. On a international truck 4300 a 2005 model with a dt466 engine it will derate and has no power but has no codes and on Driver said he driving about 50 mph on 2 lane road when he realized something was wrong because the cruise control stopped. He said the accelerator was slightly. Look at the back of the key switch and see if the wires are burnt in the connector.
It will make noise if the engine is running. Do you mean it will not turn over when you turn the key? If so, do you hear a click when you turn the key to start? If you hear a. Turbo no end play and spins free from both sides no bad vanes.
